
IndustrialPro™ and MobilityPro™ Gateway Wireless Modems
BT Series Firmware Release Notes
Sixnet, Inc. FLEXIBLE. RELIABLE. POWERFUL.
331 Ushers Road, Ballston Lake, NY 12019 T +1 518 877 5173 F +1 518 877 8346
www.sixnet.com
Version 3.8.12 © 2012. Sixnet. All Rights Reserved.
Fixed Issues
An incorrect IP settings in AT+BIPREG was crashing the modem
1156 AT
Modem failed to properly close the telnet to ports 5070/6070 when the peer
terminates the connection.
1159 AT
ERROR since the response is too long to fit in the AT
command response buffer. The results may now be obtained by issuing successive
AT+COPN commands.
1162 AT
Modem may restart randomly when AT+BMDIAG? is automatically issued at very high
frequency.
5000) had an invalid device ID in BEP messages.
AT command response was restricted to short strings.
Reduce latency to send first BEP message
1167 Events
IMOM (Initial Mobile Originated Manageme
nt) Server errors are logged too frequently.
IMOM connection to a remote server is now only attempted every 30 minutes.
The IP registration message sent by GSM modems had an extra white space.
Demand mode and not connected to WAN.
The application was occasionally failing to start.
Add WD to recover from a failure to connect in on
1048 RF (HSPA)
Show the HSPA packet session status in the RF state
of AT+BMDIAG? and AT+BNSTAT?
of HSPA modems.
1103 RF (HSPA)
enabling the HSPA RF module transmit (AT+BRFPON=1) is no longer triggering a
modem reset.
Modem to report only the RSSI of the active cell (HSPA).
Komentarze do niniejszej Instrukcji